TENDA PH6 Gigabit PowerLine Adapter Kit AV1000
Tenda PH6 is a set consisting of two PLC powerlines in the HomePlugAV2 standard. The devices have 1 Gigabit Ethernet port (10/100/1000 Mb/s) and are distinguished by low own power consumption (maximum 3.2 W). They are mounted directly in an electrical outlet, without the use of additional cables.
PLC powerlines are used to transmit the Internet network via an existing electrical network. They are perfect wherever it is not possible to mount a standard Ethernet cable. The maximum theoretical bandwidth is 1000 Mbps, but it should be remembered that it is largely dependent on the quality of the electrical network.
An additional advantage is the built-in electrical outlets, to which you can connect other devices. Thanks to this, by connecting the transmitter you do not lose access to the outlet. PH6 have been pre-configured, just plug them in, no pairing required.
Key features:
- transmission of the internet network over the existing electrical network;
- 1 Gigabit Ethernet port 10/100/1000 Mbps;
- HomePlugAV2 standard;
- maximum theoretical throughput of 1000 Mb/s (depends on the quality of the electrical installation);
- transmitters have built-in electrical sockets;
- devices pre-configured, no need to pair.
Specification:
| PH6 Kit |
| Maximum theoretical throughput |
1000 Mbps |
| Standards and protocols |
HomePlugAV2
802.3 IEEE
IEEE 802.3u
IEEE 802.3ab
|
| Ethernet interface |
1 Gigabit Ethernet port
10/100/1000 Mbps
|
| Modulation |
OFDM
CSMA/CA
|
| Buttons |
1x pairing / reset |
| Leds |
1x power
1x powerline (connection via the electrical network)
1x ethernet
|
| Power consumption |
Maximum: 3.2 W
Minimum: 0.36 W
|
| Power input |
100 - 240 VAC
50/60 Hz
0.1 A
|
| Frequency |
2 - 86 MHz |
| Dimensions |
108.5 x 61.5 x 45 mm |
| Composition of the set |
Device
Quick Installation Guide
Patch cord
|
| Permissible operating temperature |
From 0 to 40 deg.C |
| Storage temperature |
-40 to 70 deg.C |
| Permissible air humidity |
10%-90% RH non-condensing |
|
Permissible air humidity
during storage
|
5%-90% RH non-condensing |